• PM engine set valves and bridges (Spark plugs, combustion sensors, oil filters, hydrax filter and change hydrax oil)
• Install new piston and liner with new rings on cylinder 8 (1 head gasket set, new piston, new liner, new liner Orings, New piston rings)
• Top End: Exchange heads, Head gasket, Exchange check valves (reuse prechambers, Exchange wastegate, Exchange turbo with gaskets
• Replace all connecting rod bearings with new nuts and bolts
• Clean engine base out and install new door Orings and valve cover Orings
• 1 hour dyno test (Witness Test)
• Paint to customer specifications

Virginia Transformer; KVA: 16000/20000; HV: 12000; LV: 4160Y/2400

Unit is located in the USA

Operating conditions 

15 psi suction 

1165 discharge 

900 RPM

Calc. Flow 6.3 MMSCF/d 

Engine and compressor comes with

Hot starts 

20" 150 Catalytic Converter DCL International Inc.

stainless exhaust 

Maxim muffler

400 HP, 3600 RPM, GE, FRAME 315H/J, BBTEFC, 460V, NEW, UNUSED

·         120 Volt Space Heaters

·         (2) 100 Ohm Platinum Bearing RTD’s (1 per bearing)

·         (6) 100 Ohm Platinum Stator Winding RTD’s (2 per phase)

·         2 Year Factory Warranty

·         Div 2, Class 1, CSA

New Cooling unit Design for Waukesha L5774LT- JGK4 - 2 stage, 655(IC1)/1287(IC2) psig mawp

Coolers available on the ground near Calgary, available for a new compresion apllication or for a retrofit.

These coolers could save a new packaging project substanital costs.

New Surplus

Borescope report / Pictures available 

Inspection completed September 30th 2020

Engine

Brand Cummins

Model QSK50-G4 NR2

Serial Number 25434250

Manufacture Date 2018

Fuel Type Diesel

Governor Electronic

Engine Arrangement 3651170

Air Cleaner Dry Type

Starter 24 Volt Electric Starter

Alternator 24 Volt Alternator

Cooling Radiator Cooled

RPM 1800

Horsepower 2220

We have (4) of these lighting Tower units available. Each unit is 20kW, all have been refurbished and run perfectly. 

Each unit has 6 lights.

10" Reel Hose on Spools

660 feet

200 PSI

Victaulic Ends

(shorts ends available upon request)

General details on these units are as follows:
•    4 kt/day, steam at 75% steam/water quality @14.5Mpa (a) steam pressure 
•    Burner is designed 4:1 minimum
•    Burner NOx less than 7.9g/GJ HHV fuel heat input on Nat. gas, less than 15.8g/GJ HHV fuel heat input on alternative gasses.
•    Designed for outdoor install.
•    Burner control cubicles, control panels and other control/instruments/devices to be installed in protected/temperature-controlled area.

The complete packages were constructed and completed by TIW Wester Inc. in June of 2016. From there they were preserved and placed into storage. 
The technical design specifications, drawings and design parameters are available. Please see  the attached data and drawing package outlining the OTSG’s 

PLEASE NOTE - HRSG (Heat Recovery Steam Generator) also available if desired.